ToDo

We maintain the space collectively - as an all volunteer effort.

Physical things

• New dust control for the wood workshop: Succobus
  • Tubing:
    • Put short pipes on each T junction behind each machine; then the Valve, then a short pipe and then a bit of hose of the right length. Secure with hose clamps. We'll need to make a few wooden/plastic adaptors on the lathe to get the diameters right.
  • Electrics:
    • Run a 3 phase cable from behind the bandsaw over the wood-storage area to the Succobus box.
    • Wire up the 3 phase with the slow-starter & wire the slowstart to the control box.
  • Collector:
    • Figure out of/how we put a thin dust collector above the separator.
    • Mount this on the wall.
    • Check if we need to remove the 90 degree angles/replace by 3x30 to get better flow.
    • See if we need to attach the separate to the wall - and het the drum 'drop' down below it.

Documentation things

• We have quite a few [[Category::Tools] without foto's or where we use bland photos from HBM. To replace. Ideally in situ so you know where things are.
• Video of an expert (e.g. HenkD) replacing & adjusting the knifes on the planer/jointer with the special tool.