Vlakslijpmachine / Surface Grinder - onderhoud/maintenance informatie: verschil tussen versies

Uit MakerSpace Leiden
Ga naar: navigatie, zoeken
(Sales catalog)
Regel 28: Regel 28:
  
 
  [[Bestand:Jung-sales.pdf|200px|sales catalog]].
 
  [[Bestand:Jung-sales.pdf|200px|sales catalog]].
 +
 +
[[Bestand:Jung-schems-50.pdf|200px|schematics of HF50]].
  
 
Grind range 300mm; magchuck 320
 
Grind range 300mm; magchuck 320

Versie van 6 nov 2020 om 18:36


This equipment is safety category 2:

  • Mandatory instructions.
  • [liability waiver] on file.
  • Approval from trustees, but ok to operate alone
(but be careful/ensure you have assistance when handling very large things).


With respect to noise - be kind and considerate after 19:00 - and limit yourself to sporadic low-noise use.

This equipment is Noise Category 2:
Can be used at all hours, but in moderation.
Be considerate; if you feel you need to wear ear protection,
then only use the tool between 07:00 and 19:00.

== Afmetingen

  • 66 breed, 61cm diep voet.
  • Moter 117 diep
  • 146 cm hoog
  • 90cm breed inclusief bedienings paneel - zonder slede


Temporary page to hold the data on a possible surface grinder.

Model - most likely a Jung F40 or a variation thereof.


Sales catalog

sales catalog.
schematics of HF50.

Grind range 300mm; magchuck 320

Table 1300 x 210

Stone: 200mm x 20mm

Power: 400 v / 5.8 Ampere; 220v needed for the controls.

May need a slow starter.

Electrics - probably had some safety upgrade


Approx size including 'movement: 1350x1200'; 1600 high

Safety

Document safe-side/kickback

Document carbite/mask/etc risks.

Document alu en andere no-go materials (te zacht staal)

Document dressing en aan de opgaande kant houden van de dresser onder hoek weg van 90 graden.

Document imapct koeling & wiel opstart.

== Waarschuwingen

  • Gevaar voor wegvliegende delen
  • Gevaar voor draaiende delen
  • Gevaar voor letsel aan de handen
  • Gevaar carbide
  • Pull-in (omgekeerde kickback - werkstuk klem tussen tafel en wiel)

== Voorzieningen

  • Veiligheidsbril
  • Veilige kleiding
  • Spoeling
  • Kappen
  • Noodstop

== Maatregelen

  • Locatie noodstop onderdeel instructie
  • Veiligheidsbril
  • Veiligheidsbril
  • Veilige kleiding, haarnet
  • Gebruik stofmaster en spoeling bij carbinde, onderdeel instructie
  • Werken aan/vanaf de 'opgaande' kant - zodat het voorwerp zich niet tussen tafel en wiel kan trekken
  • Instructie wachten op stoppen wiel