MT2

This equipment is safety category 6: Other equipment with no limits.

This equipment is Noise Category 3: Can be used at all hours. No limits.

We have various MT2 (Morse Taper 2) holders and machines.

MT2 tooling setup next to the lathe

MT2 ER25 Collet Holder

MT2 to MT4 adapter to allow putting MT2 items to fit in the lathe chuck spindle

Such as:

• Pijp-center Tail - Stock Pipe Center voor dikke pijpen
• Diverse MT2 Hand chuck
• ER 25/32/40 Collets and holders met MT2 einde.
• Diverse houders en adaptors om dingen onder een hoek vast te houden. (Where are they?)
• Live centre
• Dead centre
• Tap houders. (Where are these stored?}
• 22mm drill

And these can be used on several machines:

• Abene VHF3 Metaalfrees machine
• Houtdraaibank
• Metaaldraaibank
• Drill press / boorkolom

Useful too:

• MT2/MT4 convertor