VNA - Vector Network Analyser: verschil tussen versies
(→Box content) |
(→Box content) |
||
| Regel 22: | Regel 22: | ||
# One USB-A/USB-C cable for charging and fetching graphs | # One USB-A/USB-C cable for charging and fetching graphs | ||
# 2 SMA to SMA cables, male | # 2 SMA to SMA cables, male | ||
| − | # One SMA male to U.FL male | + | # <strike>One SMA male to U.FL male</strike> |
# One closed connector, 0 ohm for calibration | # One closed connector, 0 ohm for calibration | ||
# One 50 ohm terminator, for calibration | # One 50 ohm terminator, for calibration | ||
# One open connector, for calibration | # One open connector, for calibration | ||
| − | # One SMA to SMA | + | # One inter SMA to SMA connector |
| − | # | + | # SMA male to cable top solder to boards |
# A range of 1p-1nF capacitors to help with [[RC522 RFID Vergelijking|turning MFRC522/RFC522 RFID readers]] | # A range of 1p-1nF capacitors to help with [[RC522 RFID Vergelijking|turning MFRC522/RFC522 RFID readers]] | ||
Versie van 24 mrt 2024 om 19:24
This equipment is Noise Category 3: Can be used at all hours. No limits.
This equipment is safety category 5: Equipment that is relatively fragile or expensive
- In person instructions is not mandatory.
- Reading the wiki, and following the instructions, is mandatory.
Inhoud
Manuals
Vector Network Analyser - possible manuals:
.
Currently in a box with 0802 capacitors that are suitable for RC522 RFID tuning.
Location
Electronics section
Box content
- VNA analyser
- One USB-A/USB-C cable for charging and fetching graphs
- 2 SMA to SMA cables, male
One SMA male to U.FL male- One closed connector, 0 ohm for calibration
- One 50 ohm terminator, for calibration
- One open connector, for calibration
- One inter SMA to SMA connector
- SMA male to cable top solder to boards
- A range of 1p-1nF capacitors to help with turning MFRC522/RFC522 RFID readers
Todo
Redo the foam in the box to fit the SMA cables, make the connector slot less deep & make the capacitor slots a bit bigger.
