VNA - Vector Network Analyser: verschil tussen versies
(→Making off) |
|||
| Regel 29: | Regel 29: | ||
# SMA male to cable top solder to boards | # SMA male to cable top solder to boards | ||
# A range of 1p-1nF capacitors to help with [[RC522 RFID Vergelijking|turning MFRC522/RFC522 RFID readers]] | # A range of 1p-1nF capacitors to help with [[RC522 RFID Vergelijking|turning MFRC522/RFC522 RFID readers]] | ||
| + | |||
| + | == Making off == | ||
| + | |||
| + | Files used to create the box: [[Bestand:Via-cut.svg|100px]] and [[Bestand:Via-cover.pdf|100px]]. | ||
== Todo == | == Todo == | ||
Redo the foam in the box to fit the SMA cables, make the connector slot less deep & make the capacitor slots a bit bigger. | Redo the foam in the box to fit the SMA cables, make the connector slot less deep & make the capacitor slots a bit bigger. | ||
| − | |||
| − | |||
| − | |||
| − | |||
Versie van 24 mrt 2024 om 20:40
This equipment is Noise Category 3: Can be used at all hours. No limits.
This equipment is safety category 5: Equipment that is relatively fragile or expensive
- In person instructions is not mandatory.
- Reading the wiki, and following the instructions, is mandatory.
Manuals
Vector Network Analyser - possible manuals:
.
Currently in a box with 0802 capacitors that are suitable for RC522 RFID tuning.
Location
Electronics section, shelf under the components drawers in a wooden box.
Box content
- VNA analyser
- One USB-A/USB-C cable for charging and fetching graphs
- 2 SMA to SMA cables, male
One SMA male to U.FL male- One closed connector, 0 ohm for calibration
- One 50 ohm terminator, for calibration
- One open connector, for calibration
- One inter SMA to SMA connector
- SMA male to cable top solder to boards
- A range of 1p-1nF capacitors to help with turning MFRC522/RFC522 RFID readers
Making off
Files used to create the box: 
and 
.
Todo
Redo the foam in the box to fit the SMA cables, make the connector slot less deep & make the capacitor slots a bit bigger.
