MT2: verschil tussen versies
| Regel 15: | Regel 15: | ||
* Diverse [[MT2 Hand chuck]] | * Diverse [[MT2 Hand chuck]] | ||
* [[ER 25/32/40 Collets and holders]] met MT2 einde. | * [[ER 25/32/40 Collets and holders]] met MT2 einde. | ||
| − | * Diverse houders en adaptors om dingen onder een hoek vast te houden. | + | * Diverse houders en adaptors om dingen onder een hoek vast te houden. (Where are they?) |
* Live centre | * Live centre | ||
* Dead centre | * Dead centre | ||
| − | * Tap houders. | + | * Tap houders. (Where are these stored?} |
| + | * 22mm drill | ||
And these can be used on several machines: | And these can be used on several machines: | ||
Versie van 31 mei 2024 om 21:11
This equipment is safety category 6: Other equipment with no limits.
This equipment is Noise Category 3: Can be used at all hours. No limits.
We have various MT2 (Morse Taper 2) holders and machines.
Such as:
- Pijp-center Tail - Stock Pipe Center voor dikke pijpen
- Diverse MT2 Hand chuck
- ER 25/32/40 Collets and holders met MT2 einde.
- Diverse houders en adaptors om dingen onder een hoek vast te houden. (Where are they?)
- Live centre
- Dead centre
- Tap houders. (Where are these stored?}
- 22mm drill
And these can be used on several machines:
Useful too:
