MT2: verschil tussen versies

Versie van 28 jul 2024 om 22:50

This equipment is safety category 6: Other equipment with no limits.

This equipment is Noise Category 3: Can be used at all hours. No limits.

We have various MT2 (Morse Taper 2) holders and machines. (For MT4 equipment to go in the lathe spindle, see MT4)

MT2 tooling setup next to the lathe

MT2 ER25 Collet Holder

MT2 to MT4 adapter to allow putting MT2 items to fit in the lathe chuck spindle

Such as:

Pijp-center Tail - Stock Pipe Center voor dikke pijpen
Diverse MT2 Hand chuck
ER 25/32/40 Collets and holders met MT2 einde.
Diverse houders en adaptors om dingen onder een hoek vast te houden. (Where are they?)
Live centre
Dead centre
Tap houders. (Where are these stored?}
22mm drill

And these can be used on several machines:

Useful too:

Versie van 28 jul 2024 om 22:50 (brontekst bekijken) JuliaFreeman (overleg \| bijdragen) ← Oudere bewerking		Versie van 28 jul 2024 om 22:50 (brontekst bekijken) JuliaFreeman (overleg \| bijdragen) k Nieuwere bewerking →
Regel 3:		Regel 3:
	{{SafetyCat6}}{{NoiseCat3}}		{{SafetyCat6}}{{NoiseCat3}}

−	We have various MT2 ([https://en.wikipedia.org/wiki/Machine_taper Morse Taper 2]) holders and machines. (For MT4 equipment to go in the lathe spindle, see [[MT4]]	+	We have various MT2 ([https://en.wikipedia.org/wiki/Machine_taper Morse Taper 2]) holders and machines. (For MT4 equipment to go in the lathe spindle, see [[MT4]])