Drill Press Wood / Boorkolom hout: verschil tussen versies
| Regel 8: | Regel 8: | ||
Cutting wood in the metal area is fine. Cutting metal in the wood area is frowned upon. If you do so - de-grease the machine/plateau post use ! | Cutting wood in the metal area is fine. Cutting metal in the wood area is frowned upon. If you do so - de-grease the machine/plateau post use ! | ||
| − | |||
| − | |||
See also: [[Wood Drills]], [[Large HSS drills]] and [[Spade drills]]. | See also: [[Wood Drills]], [[Large HSS drills]] and [[Spade drills]]. | ||
Versie van 25 aug 2024 om 12:41
This equipment is safety category 4:
- In-person, instructions strongly advised but not mandatory.
- Reading, and following, the instructions on the Wiki is mandatory!
This equipment is Noise Category 2:
Can be used at all hours, but in moderation.
Be considerate; if you feel you need to wear ear protection,
then only use the tool between 07:00 and 19:00.
We have two - one in the wood shop and a heavier one one in the metal area.
Cutting wood in the metal area is fine. Cutting metal in the wood area is frowned upon. If you do so - de-grease the machine/plateau post use !
See also: Wood Drills, Large HSS drills and Spade drills.
Safety
The drill press is classed as a normal, somewhat dangerous machine: instructions strongly advised but not mandatory. It can be used any hours -- but be kind to our neighbours.
Use of safety glasses will generally be needed. And the use of gloves is possible; but a mixed blessing. It increases the risk of your glove (and with it your finger) getting twisted around the drill/rotating head.
Its main risks are flying sharp bits, getting caught in something rotating or your workpiece rotating/spinning.
So clamp things well.
Changing speed
Always use the right speed; you get a nice round hole, it goes faster and the drills stay sharp.
See https://www.youtube.com/watch?v=hbig6nOl398 for a video on changing the speed.
See Boorsnelheid RPM drilling speed voor de snelheden.
See also SnijOlie BoorOlie CuttingOil
Speeds and oil (metal)
There is a chart of speeds on the wall -- or see http://engineering.ucdavis.edu/wp-content/uploads/2013/08/lathespeeds.pdf
The larger your drill diameter - the lower the speed (Alu faster than steel faster than stainlesssteel/rvs); but limit countersinks/counterbores/stepdrills and similar `specials' to 200-300RPM.
There are three types of oil next to the machine. For most metals use the green oil.
Use the non-ferro oil if you find that the green oil stains your aluminiun/non-ferro metal (this is quite rare).
The third oil is generally not suitable to use with this drill press.
