3D Scanner: verschil tussen versies
(→Ownership) |
|||
| Regel 17: | Regel 17: | ||
== Ownership == | == Ownership == | ||
| − | The Mac Mini, Kinekt and PSU are owned by Dirk-Willem van Gulik (zie { | + | The Mac Mini, Kinekt and PSU are owned by Dirk-Willem van Gulik (zie {[[Category:OnLoan]]) and to be '''kept at the makerspace''' at all times. No exceptions. |
== Usage == | == Usage == | ||
Versie van 16 nov 2019 om 23:16
Work in progress
We have a 3D scanner based on a Microsoft XBox Kinekt device, the [Snanect] software and a Mac Mini.
Instructions for use
- Log in as Guest
- Start the Scanect Software
- Configure for a BOX scan (1x1 is about righ).
- Go through each of the steps.
- Save the resulting file (PLY) to a USB disk
Ownership
The Mac Mini, Kinekt and PSU are owned by Dirk-Willem van Gulik (zie {) and to be kept at the makerspace at all times. No exceptions.
Usage
This equipment is safety category 5: Equipment that is relatively fragile or expensive
- In person instructions is not mandatory.
- Reading the wiki, and following the instructions, is mandatory.
This equipment is Noise Category 3: Can be used at all hours. No limits.
