3D Scanner

XX replace by something taken in the space !

Work in progress

We have a 3D scanner based on a Microsoft XBox Kinekt device, the [Snanect] software and a Mac Mini.

Instructions for use

• Log in as Guest
• Start the Scanect Software
• Configure for a BOX scan (1x1 is about righ).
• Go through each of the steps.
• Save the resulting file (PLY) to a USB disk

Ownership

The Mac Mini, Kinekt and PSU are owned by Dirk-Willem van Gulik (zie Category:OnLoan) and to be kept at the makerspace at all times. No exceptions.

Reinstall from 'zero'

If the machine ever needs to be re-installed -- then know that using the cmd-alt-R recovery method will bring it back to a rather old version of OSX (Mountain Lion). Which is too old for a `decent' version of Skanect.

So you will have to upgrade to High Sierra (the max for this class of hardware).

To upgrade it from that point - you have three options - none overly attractive:

1. Find someone who has a AppStore account that is that old - and which has gone through all these OS upgrades in the past. That person will have the required installs in his or her `Purchased' set. Note that you cannot go straight to High Sierra- you need one stepping stones (such as El Captain) as you are just outside the '8 year' jump range.
2. Follow the instructions on https://www.macworld.co.uk/how-to/mac-software/download-old-os-x-3629363/
3. Make a USB bootable USB disk. Either by following apples instructions or using http://dosdude1.com/highsierra/. The USB stick needs to be 8Gbyte or bigger.

In all cases - if you get a 'OS X could not be installed on your computer. No packages were eligible for install' erorr - then, in that same, screen, select the Terminal option under tools/utilities - and set the date to some date in 2015 using the `date(1)' command.

Once the install is done - force the time to be correct (the startup may be very slow if you leave the network connected) -- as it will otherwise hang/timeout/bomb on all SSL requests.

Once this is done - lock down the machine; install skanect and/or RTAB-Map according to instructions. And that is it. No drivers needed.

Usage

This equipment is safety category 5: Equipment that is relatively fragile or expensive

• In person instructions is not mandatory.
• Reading the wiki, and following the instructions, is mandatory.

This equipment is Noise Category 3: Can be used at all hours. No limits.