3D Scanner: verschil tussen versies
(→Reinstall from 'zero') |
(→Work in progress) |
||
| Regel 3: | Regel 3: | ||
[[Bestand:Kinect.jpg|miniatuur|XX replace by something taken in the space !]] | [[Bestand:Kinect.jpg|miniatuur|XX replace by something taken in the space !]] | ||
| − | |||
We have a 3D scanner based on a Microsoft XBox Kinekt device, the [[https://skanect.occipital.com Skanect]] software and a Mac Mini. | We have a 3D scanner based on a Microsoft XBox Kinekt device, the [[https://skanect.occipital.com Skanect]] software and a Mac Mini. | ||
| + | |||
| + | = Still to do = | ||
| + | |||
| + | # Pull the ethernet cable (big coil near electronics desks) throught the conduit to where the mac-mini is. | ||
| + | # Make a turn table | ||
| + | # Write better manual | ||
= Instructions for use = | = Instructions for use = | ||
Versie van 18 nov 2019 om 22:42
We have a 3D scanner based on a Microsoft XBox Kinekt device, the [Skanect] software and a Mac Mini.
Inhoud
Still to do
- Pull the ethernet cable (big coil near electronics desks) throught the conduit to where the mac-mini is.
- Make a turn table
- Write better manual
Instructions for use
- Log in as Guest
- Start the Scanect Software
- Configure for a BOX scan (1x1 is about righ).
- Go through each of the steps.
- Save the resulting file (PLY) to a USB disk or SD card (slot is on the back, left hand side)
Maintenance
Check, every 2-3 months, of all updates ran.
Reinstall from 'zero'
See 3D Scanner - installation notes for more information.
Ownership
The Mac Mini, Kinekt and PSU are owned by Dirk-Willem van Gulik (zie Category:OnLoan) and to be kept at the makerspace at all times. No exceptions.
Usage
This equipment is safety category 5: Equipment that is relatively fragile or expensive
- In person instructions is not mandatory.
- Reading the wiki, and following the instructions, is mandatory.
This equipment is Noise Category 3: Can be used at all hours. No limits.
