3D Scanner: verschil tussen versies
| Regel 1: | Regel 1: | ||
[[Category:CNC]][[Category:SafetySheet]][[Category:Tool]][[Category:Manual]][[Category:Notes]][[Category:Measuring]] | [[Category:CNC]][[Category:SafetySheet]][[Category:Tool]][[Category:Manual]][[Category:Notes]][[Category:Measuring]] | ||
| − | [[Bestand: | + | [[Bestand:Kinnectdeelnemer.JPG|miniatuur|]] |
| Regel 18: | Regel 18: | ||
* Configure for a BOX scan (1x1 is about righ for a think - 3x3 for a person).(kies object of body) | * Configure for a BOX scan (1x1 is about righ for a think - 3x3 for a person).(kies object of body) | ||
* Go through each of the steps in Scannekt. | * Go through each of the steps in Scannekt. | ||
| − | * resultaat kan je bewaren als .stl share, export model | + | * resultaat kan je bewaren als .stl (share, export model) |
* Save the resulting file (PLY) to a USB disk or SD card (slot is on the back, left hand side) | * Save the resulting file (PLY) to a USB disk or SD card (slot is on the back, left hand side) | ||
Versie van 23 nov 2019 om 14:46
We have a 3D scanner based on a Microsoft XBox Kinekt device, the [Skanect] software and a Mac Mini.
Inhoud
Still to do
- Pull the ethernet cable (big coil near electronics desks) throught the conduit to where the mac-mini is.
- Make a turn table
- Write better manual
Instructions for use
- Log in as Guest
- Start the Scanekt Software (in /Applications) vierkante smiley dan opent nieuw scherm, linkerbalk vind je applications, en kies dan skanect
- Configure for a BOX scan (1x1 is about righ for a think - 3x3 for a person).(kies object of body)
- Go through each of the steps in Scannekt.
- resultaat kan je bewaren als .stl (share, export model)
- Save the resulting file (PLY) to a USB disk or SD card (slot is on the back, left hand side)
Maintenance
Check, every 2-3 months, of all updates ran.
Reinstall from 'zero'
See 3D Scanner - installation notes for more information.
Ownership
The Mac Mini, Kinekt and PSU are owned by Dirk-Willem van Gulik (zie Category:OnLoan) and to be kept at the makerspace at all times. No exceptions.
The UK/NL adapter was donated by Hans. The screen, HMDI/DVI cable and mouse were donated by Hans Beerman.
Usage
This equipment is safety category 5: Equipment that is relatively fragile or expensive
- In person instructions is not mandatory.
- Reading the wiki, and following the instructions, is mandatory.
This equipment is Noise Category 3: Can be used at all hours. No limits.
