Hamer Hout / Hammer Wood: verschil tussen versies

Uit MakerSpace Leiden
Ga naar: navigatie, zoeken
(Wooden mallets)
(Orange Dead Blow hammers (terugslagloze hamers)
Regel 25: Regel 25:
 
Serve the same purpose as wooden mallets - but have the advantage that they do not bounce back (the head is filled with sand).
 
Serve the same purpose as wooden mallets - but have the advantage that they do not bounce back (the head is filled with sand).
  
Not suitable for wacking metal things. For that use the special metal-wacking hammer which is on the board behind the [[Abene VHF3 Metaalfrees machine]].
+
Not suitable for whacking metal things. For that use the special metal-wacking hammer which is on the board behind the [[Abene VHF3 Metaalfrees machine]].

Versie van 19 mei 2019 om 12:39

This equipment is safety category 6: Other equipment with no limits.

This equipment is Noise Category 3: Can be used at all hours. No limits.

Various Hammers - owned by the Space.

Do not use these hammers near oil or other things that can soil them (and the next persons work). Silicon and oil residue in particular will ruin certain laquer and paintworks; even in minute quantities. There are general purpose hammers in the Metal section that should be used for that.


General Wood Hammers

Hammers (wood section only)

A claw hammer and 2 normal hammers. Can be used for anything that needs a wack - such as nails.

Do not hammer other hammers or similar (tool) metal. Things will shatter.

Wooden mallets

The two wooden mallets are for wacking wooden things without damaging them.

Really not suitable for whacking metal things. For that use the special metal-wacking hammer which is on the board behind the Abene VHF3 Metaalfrees machine.

Orange Dead Blow hammers (terugslagloze hamers

Dead Blow Hammers (wood section only)

Serve the same purpose as wooden mallets - but have the advantage that they do not bounce back (the head is filled with sand).

Not suitable for whacking metal things. For that use the special metal-wacking hammer which is on the board behind the Abene VHF3 Metaalfrees machine.