3D Scanner

XX replace by something taken in the space !

We have a 3D scanner based on a Microsoft XBox Kinekt device, the [Skanect] software and a Mac Mini.

Still to do

1. Pull the ethernet cable (big coil near electronics desks) throught the conduit to where the mac-mini is.
2. Make a turn table
3. Write better manual

Instructions for use

• Log in as Guest
• Start the Scanect Software
• Configure for a BOX scan (1x1 is about righ).
• Go through each of the steps.
• Save the resulting file (PLY) to a USB disk or SD card (slot is on the back, left hand side)

Maintenance

Check, every 2-3 months, of all updates ran.

Reinstall from 'zero'

See 3D Scanner - installation notes for more information.

Ownership

The Mac Mini, Kinekt and PSU are owned by Dirk-Willem van Gulik (zie Category:OnLoan) and to be kept at the makerspace at all times. No exceptions.

Usage

This equipment is safety category 5: Equipment that is relatively fragile or expensive

• In person instructions is not mandatory.
• Reading the wiki, and following the instructions, is mandatory.

This equipment is Noise Category 3: Can be used at all hours. No limits.