Mechanics Drill bit, Korte Boren, DIN1897: verschil tussen versies
| Regel 12: | Regel 12: | ||
Be somewhat careful for them - as they are time consuming to replace. And, also for this reason, do alert the mailing list if you break one -- as the typical cases where a such a drill is needed - is one where a normal drill will really not be a good substite. So we can get replacements timely. | Be somewhat careful for them - as they are time consuming to replace. And, also for this reason, do alert the mailing list if you break one -- as the typical cases where a such a drill is needed - is one where a normal drill will really not be a good substite. So we can get replacements timely. | ||
| − | This in addition to the normal, jobber length, HSS and cobalt drills that are next to the two pillar drills in the wood and metal shop. | + | This in addition to the [[Metal Drills|normal, jobber length, HSS and cobalt drills]] that are next to the two pillar drills in the wood and metal shop. Or check the page [[:Category:Boren]] for a full list. |
= See also = | = See also = | ||
The [[Large HSS drills]] en [[Boorsnelheid RPM drilling speed|Boorsnelheid RPM / drilling speed]] | The [[Large HSS drills]] en [[Boorsnelheid RPM drilling speed|Boorsnelheid RPM / drilling speed]] | ||
Versie van 8 mei 2023 om 16:21
This equipment is safety category 6: Other equipment with no limits.
This equipment is Noise Category 3: Can be used at all hours. No limits.
We have a special set of DIN1897 'jobber' drills for metal. Sizes 1mm to 10mm in steps of 0.5.
These are extra short drills for hard metal that are stiffer than the normal jobber length drills.
Be somewhat careful for them - as they are time consuming to replace. And, also for this reason, do alert the mailing list if you break one -- as the typical cases where a such a drill is needed - is one where a normal drill will really not be a good substite. So we can get replacements timely.
This in addition to the normal, jobber length, HSS and cobalt drills that are next to the two pillar drills in the wood and metal shop. Or check the page Category:Boren for a full list.
