Router Table / Tafelfrees: verschil tussen versies
(Nieuwe pagina aangemaakt met 'Category:SafetySheetCategory:ToolCategory:WoodCategory:Metal{{SafetyCat3}}{{NoiseCat2}}Category:OnLoan Router Table. '''WARNING: has an imperi...') |
|||
Regel 3: | Regel 3: | ||
Router Table. | Router Table. | ||
− | '''WARNING: has an imperial collet ! | + | '''WARNING: has an imperial collet !''' |
− | ''' | + | |
+ | Be very careful with the collet sizes; a 1/4 of an inch is almost 6mm - but not quite. Putting a 6mm bit into a 1/4th of an inch collet will absolotely ruin it. And they are expensive and hard to replace (long lead team; 30-60 euro's). | ||
+ | |||
= Ownership = | = Ownership = | ||
Owned by HansD. See [[:Category:OnLoan]]. | Owned by HansD. See [[:Category:OnLoan]]. |
Versie van 8 jan 2019 om 20:15
This equipment is safety category 3:
- Mandatory, in person, instructions.
- Make sure you read the Wiki before asking.
This equipment is Noise Category 2:
Can be used at all hours, but in moderation.
Be considerate; if you feel you need to wear ear protection,
then only use the tool between 07:00 and 19:00.
Router Table.
WARNING: has an imperial collet !
Be very careful with the collet sizes; a 1/4 of an inch is almost 6mm - but not quite. Putting a 6mm bit into a 1/4th of an inch collet will absolotely ruin it. And they are expensive and hard to replace (long lead team; 30-60 euro's).
Ownership
Owned by HansD. See Category:OnLoan.