Thermometer: verschil tussen versies

Uit MakerSpace Leiden
Ga naar: navigatie, zoeken
(History)
 
(Een tussenliggende versie door dezelfde gebruiker niet weergegeven)
Regel 7: Regel 7:
 
The space has a K-thermocouple thermometer with several probes; including a 'long' one to stick into ovens.
 
The space has a K-thermocouple thermometer with several probes; including a 'long' one to stick into ovens.
  
See this [[media:thermometer-k.pdf|manual]] for the instructions.  
+
Read this [[media:thermometer-k.pdf|manual]] for the instructions.
 +
 
 +
Note - we're not quite sure that the low cost (but quite accurate) 30cm stick actually is able to measure the full temperature range. So do not feel guilty if it melts - do report it though (so we can order a proper one).
 +
 
 +
See also the [[FLIR camera]] and [[Optical Thermometer]].
  
 
= Box content =
 
= Box content =

Huidige versie van 29 mrt 2024 om 19:58


Thermocouple meter

This equipment is Noise Category 3: Can be used at all hours. No limits.

This equipment is safety category 5: Equipment that is relatively fragile or expensive

  • In person instructions is not mandatory.
  • Reading the wiki, and following the instructions, is mandatory.

The space has a K-thermocouple thermometer with several probes; including a 'long' one to stick into ovens.

Read this manual for the instructions.

Note - we're not quite sure that the low cost (but quite accurate) 30cm stick actually is able to measure the full temperature range. So do not feel guilty if it melts - do report it though (so we can order a proper one).

See also the FLIR camera and Optical Thermometer.

Box content

  • One meter (needs 9v battery)
  • One 30cm 'stick' probe
  • Two short wire probes
  • 2 page manual

Location

Thermocouple meter

3D Printer rack in wooden box - near the FLIR camera.

History and Ownership

Bought by the space March 2024 with 3 probes.

Last battery change 2023/03/29.