VNA - Vector Network Analyser: verschil tussen versies
(→Box content) |
(→Box content) |
||
| Regel 28: | Regel 28: | ||
# One SMA to SMA extension cable | # One SMA to SMA extension cable | ||
# Some random SMA bits to help soldering during measurement | # Some random SMA bits to help soldering during measurement | ||
| + | # A range of 1p-1nF capacitors to help with [[RC522 RFID Vergelijking|turning MFRC522/RFC522 RFID readers]] | ||
== Todo == | == Todo == | ||
Redo the foam in the box to fit the SMA cables, make the connector slot less deep & make the capacitor slots a bit bigger. | Redo the foam in the box to fit the SMA cables, make the connector slot less deep & make the capacitor slots a bit bigger. | ||
Versie van 24 mrt 2024 om 20:23
This equipment is Noise Category 3: Can be used at all hours. No limits.
This equipment is safety category 5: Equipment that is relatively fragile or expensive
- In person instructions is not mandatory.
- Reading the wiki, and following the instructions, is mandatory.
Inhoud
Manuals
Vector Network Analyser - possible manuals:
.
Currently in a box with 0802 capacitors that are suitable for RC522 RFID tuning.
Location
Electronics section
Box content
- VNA analyser
- One USB-A/USB-C cable for charging and fetching graphs
- 2 SMA to SMA cables, male
- One SMA male to U.FL male
- One closed connector, 0 ohm for calibration
- One 50 ohm terminator, for calibration
- One open connector, for calibration
- One SMA to SMA extension cable
- Some random SMA bits to help soldering during measurement
- A range of 1p-1nF capacitors to help with turning MFRC522/RFC522 RFID readers
Todo
Redo the foam in the box to fit the SMA cables, make the connector slot less deep & make the capacitor slots a bit bigger.
