Drills, Machinist set: verschil tussen versies
| Regel 9: | Regel 9: | ||
= Instructions mandatory = | = Instructions mandatory = | ||
| − | This is for use of those that had [[Huvema HU760 Draaibank|Metal lathe]] and [[Abene | + | This is for use of those that had [[Huvema HU760 Draaibank|Metal lathe]] and [[Abene Metal Mill / Freesbank|Metal mill]] instructions '''only'''. |
See [[Metal Drills]] and [[:Category:Drills]] for general use drills. | See [[Metal Drills]] and [[:Category:Drills]] for general use drills. | ||
Versie van 28 okt 2024 om 22:35
This equipment is Noise Category 3: Can be used at all hours. No limits.
This equipment is safety category 3:
- Mandatory, in person, instructions.
- Make sure you read the Wiki before asking.
We keep a set of drills; 0.1mm steps separate from our normal Metal_Drills in the blue cabinet.
Instructions mandatory
This is for use of those that had Metal lathe and Metal mill instructions only.
See Metal Drills and Category:Drills for general use drills.
See also
Boorsnelheid RPM / drilling speed and Cutting oil
Location
Blue cabinet. Metal lathe and Metal mill instructions mandatory.
History
Sets donated by Dirk-Willem mid 2019.
Sets replaced 8/6/2023 (paid by MSL)
