3D Scanner: verschil tussen versies
(→Ownership) |
(→Instructions for use) |
||
| Regel 15: | Regel 15: | ||
* Log in as Guest | * Log in as Guest | ||
| − | * Start the | + | * Start the Scanekt Software (in /Applications) |
| − | * Configure for a BOX scan (1x1 is about righ). | + | * Configure for a BOX scan (1x1 is about righ for a think - 3x3 for a person). |
| − | * Go through each of the steps. | + | * Go through each of the steps in Scannekt. |
* Save the resulting file (PLY) to a USB disk or SD card (slot is on the back, left hand side) | * Save the resulting file (PLY) to a USB disk or SD card (slot is on the back, left hand side) | ||
Versie van 18 nov 2019 om 23:51
We have a 3D scanner based on a Microsoft XBox Kinekt device, the [Skanect] software and a Mac Mini.
Inhoud
Still to do
- Pull the ethernet cable (big coil near electronics desks) throught the conduit to where the mac-mini is.
- Make a turn table
- Write better manual
Instructions for use
- Log in as Guest
- Start the Scanekt Software (in /Applications)
- Configure for a BOX scan (1x1 is about righ for a think - 3x3 for a person).
- Go through each of the steps in Scannekt.
- Save the resulting file (PLY) to a USB disk or SD card (slot is on the back, left hand side)
Maintenance
Check, every 2-3 months, of all updates ran.
Reinstall from 'zero'
See 3D Scanner - installation notes for more information.
Ownership
The Mac Mini, Kinekt and PSU are owned by Dirk-Willem van Gulik (zie Category:OnLoan) and to be kept at the makerspace at all times. No exceptions.
The UK/NL adapter was donated by Hans. The screen, HMDI/DVI cable and mouse were donated by Hans Beerman.
Usage
This equipment is safety category 5: Equipment that is relatively fragile or expensive
- In person instructions is not mandatory.
- Reading the wiki, and following the instructions, is mandatory.
This equipment is Noise Category 3: Can be used at all hours. No limits.
