Huidige versie van 8 mei 2023 om 16:20

This equipment is safety category 6: Other equipment with no limits.

This equipment is Noise Category 3: Can be used at all hours. No limits.

These are generic large size drills (sizes 14, 16, 17,18, 19, 20,22 and 25) for use in wood, plastic, metal, etc.

Consult a table with RPMs - as that really starts to matter at these sizes.

Also; unless you are dealing with very soft wood - expect to drill in steps of 1-3mm; going from small to large.

See [[Metal Drills] and Categorie:Boren for normal size drills.

Inhoud

If you need to drill through material (e.g. sheets) that is 1/4 of the drill diameter of thinner; check the various tricks on YouTube first (https://www.giangrandi.org/mechanics/sheetmetaldrill/sheetmetaldrill.shtml).

And generally - using one of the Step-drill/getrapte boor works better; or the Grote Gaten Zaag - Large Hole Saw for bigger holes.

One box in the wood shop; one in the metal shop. Both near the Drill press / boorkolom

Owned by the space; bought early March 2020.

@@ Regel 1: / Regel 1: @@
-[[Categorie:Tool]][[Categorie:Metal]][[Categorie:Small]][[Categorie:Wood]]
+[[Categorie:Tool]][[Categorie:Metal]][[Categorie:Small]][[Categorie:Wood]][[Categorie:Boren]]
 {{SafetyCat6}}
 {{NoiseCat3}}
@@ Regel 9: / Regel 9: @@
 [[Bestand:large-box2.jpeg| 400px |Doos HSS groot, metaal]]
-Consult a table with RPMs - as that starts to matter at these sizes.
+Consult a [[Boorsnelheid RPM drilling speed|table with RPMs]] - as that really starts to matter at these sizes.
 Also; unless you are dealing with very soft wood - expect to drill in steps of 1-3mm; going from small to large.
+See [[Metal Drills] and [[:Categorie:Boren]] for normal size drills.
 = Thin material =