Stappen Boor StepDrill: verschil tussen versies
(→See also) |
(→Breaking Drills) |
||
| Regel 16: | Regel 16: | ||
You can expense these. | You can expense these. | ||
| + | |||
| + | = Speed = | ||
| + | |||
| + | Keep the speed LOW; about half of a normal HSS twist drill of that diameter. | ||
= See also = | = See also = | ||
The [[Grote_Gaten_Zaag_-_Large_Hole_Saw]], [[Large HSS drills]] en [[Boorsnelheid RPM drilling speed|Boorsnelheid RPM / drilling speed]] | The [[Grote_Gaten_Zaag_-_Large_Hole_Saw]], [[Large HSS drills]] en [[Boorsnelheid RPM drilling speed|Boorsnelheid RPM / drilling speed]] | ||
Huidige versie van 12 jan 2024 om 16:21
This equipment is safety category 6: Other equipment with no limits.
This equipment is Noise Category 3: Can be used at all hours. No limits.
We have various stepper drills. To make round holes in thin material.
This in addition to the normal, jobber length, HSS and cobalt drills that are next to the two pillar drills in the wood and metal shop. Or check the page Category:Boren for a full list.
Breaking Drills
If you break them - that is fine. Happens.
In that case - either replace them -or- report it to the mailing list so someone else can replace them.
You can expense these.
Speed
Keep the speed LOW; about half of a normal HSS twist drill of that diameter.
See also
The Grote_Gaten_Zaag_-_Large_Hole_Saw, Large HSS drills en Boorsnelheid RPM / drilling speed
